Prerequisites to install Nuvolaris in an Azure AKS Cluster
Azure AKS is a pre-built Kubernetes cluster offered by the cloud provider Microsoft Azure.
You can create an AKS Cluster in Microsoft Azure for installing using Nuvolaris using nuv as follows:
-
install
az, the Azure CLI -
optionally, retrieve the load balancer address to configure a DNS name
Once you have AKS up and running you can proceed configuring and installing Nuvolaris.
Installing the Azure CLI
Our CLI nuv uses under the hood the Azure CLI, so you need to dowload and install it following those instructions.
Once installed, ensure it is available on the terminal executing the following command:
az version
you should receive something like this:
{
"azure-cli": "2.51.0",
"azure-cli-core": "2.51.0",
"azure-cli-telemetry": "1.1.0",
"extensions": {}
}
Configuring Azure AKS
Before provisioning your AKS cluster you need to configure AKS with the command nuv config aks answering to all the questions, as in the following example:
$ nuv config aks *** Please, specify AKS Name for Cluster and Resource Group and press enter. Just press enter for default [nuvolaris]: *** Please, specify AKS number of worker nodes and press enter. Just press enter for default [3]: *** Please, specify AKS location and press enter. To get a list of valid values use: az account list-locations -o table Just press enter for default [eastus]: *** Please, specify AKS virtual machine type and press enter. To get a list of valid values use: az vm list-sizes --location <location> -o table where <location> is your current location. Just press enter for default [Standard_B4ms]: *** Please, specify AKS disk size in gigabyte and press enter. Just press enter for default [50]: *** Please, specify AKS public SSH key in AWS and press enter. If you already have a public SSH key provide its path here. If you do not have it, generate a key pair with the following command: ssh-keygen The public key defaults to ~/.ssh/id_rsa.pub. Just press enter for default [~/.ssh/id_rsa.pub]:
Provisioning Azure AKS
Once you have configured it, you can create the AKS cluster with the command:
nuv cloud aks create
It will take around 10 minutes to be ready. Please be patient.
At the end of the process, you will have access directly to the created Kubernetes cluster for installation.
Retrieving the Load Balancer DNS name
Once the cluster is up and running, you need to retrieve the DNS name of the load balancer.
You can read this with the command:
nuv cloud aks lb
Take note of the result as it is required for configuring a dns name for your cluster.